How To Install A Shower Base

Use reference marks on the subfloor to fine tune the location of the drain.

How to install a shower base. Video sharing camera phone video phone free upload. Clear all debris and old adhesive from the surface. Place the shower pan onto the mortar making sure the pre drilled holes on its rim line up with the wall studs.

Attach the drain fitting into the shower base. To apply the mortar bed spread it evenly around the shower area. Use a broom or a vacuum to clear loose debris.

Screw the drain fitting onto the base and make sure that it is tight. Use a wide blade putty knife or a paint scraping tool to peel off old caulking and adhesive. Install a drain dam inside the drain pipe or drain hole to prevent mortar from falling through it.

This is usually 24 to 48 hours. Place cardboard or another material into the shower pan base to protect its surface. Apply plumber s putty to the bottom of the flange on the drain fitting before installing it.

Press the shower pan base into the mortar adjusting it until the entire base is level. Set the shower base in place to double check the final placement of the p trap inserting a short temporary tailpiece. Prepare the area for installation.

Remove the base and install the shower drain fitting into the opening in the shower base. Make any additional surface preparations that are recommended by the shower pan manufacturer as necessary such as applying a fresh coat of a water seal product to the. The idea is to create a flat surface for the shower base to lay on.